Ryobi P206 - Manual (Page 13)

13
2
0
24
5
2
0
24
5
2
0
24
5
SCREWDRIVER BIT
SCREWDRIVER BIT
LO
SPEED
HI
SPEED
TWO-SPEED
GEAR TRAIN (HI-LO)
OPERATION
TWO-SPEED GEAR TRAIN
See Figure 7.
The drill has a two-speed gear train designed for drilling or
driving at
LO (1) or HI (2) speeds. A slide switch is located on
top of the drill to select either LO (1) or HI (2) speed. When
using drill in the LO (1) speed range, speed will decrease
and unit will have more power and torque. When using drill
in the
HI (2) speed range, speed will increase and unit will
have less power and torque. Use LO (1) speed for high power
and torque applications and HI (2) speed for fast drilling or
driving applications.
ADJUSTABLE TORQUE CLUTCH
This product is equipped with an adjustable torque
clutch for driving different types of screws into different ma-
terials. The proper setting depends on the type of material
and the size of screw you are using.
ADJUSTING TORQUE
See Figure 8.
There are twenty-four torque indicator settings located on
the front of the drill.
n Rotate adjustment ring to the desired setting.
• 1 - 4 For driving small screws
• 5 - 8 For driving screws into soft material
• 9 - 12 For driving screws into soft and hard
materials
• 13 - 16 For driving screws in hard wood
• 17 - 20 For driving large screws
• 21 -
For heavy drilling
BIT STORAGE
See Figure 9.
When not in use, bits provided with the drill can be placed in
the storage area located on the top of motor housing.
Fig. 7
Fig. 8
Fig. 9
TO DECREASE
TORQUE
TO INCREASE
TORQUE
TORQUE
ADJUSTMENT RING
1
2
BIT
STORAGE AREA