Ryobi P206 - Manual (Page 15)

15
20
2 0 15
DRILLING
See Figure 13 - 14.
Levels are located on the top and end of the motor hous-
ing to help keep the drill bit level during use.
n
Check the direction of rotation selector for the correct
setting (forward or reverse).�
n Secure the material to be drilled in a vise or with clamps
to keep it from turning as the drill bit rotates.�
n Hold the drill firmly and place the bit at the point to be
drilled.�
n Depress the switch trigger to start the drill.
n Move the drill bit into the workpiece, applying only enough
pressure to keep the bit cutting. Do not force the drill or
apply side pressure to elongate a hole. Let the tool do
the work.
WARNING :
Be prepared for binding at bit breakthrough. When these
situations occur, the drill has a tendency to grab and kick
in the opposite direction and could cause loss of control
when breaking through material. If not prepared, this loss
of control can result in possible serious injury.
n When drilling hard, smooth surfaces, use a center punch
to mark the desired hole location. This will prevent the
drill bit from slipping off-center as the hole is started.
n When drilling metals, use a light oil on the drill bit to keep
it from overheating. The oil will prolong the life of the bit
and increase the drilling action.
n If the bit jams in the workpiece or if the drill stalls, stop
the tool immediately. Remove the bit from the workpiece
and determine the reason for jamming.
NOTE: This drill has an electric brake. When the switch trig-
ger is released, the chuck stops turning. When the brake is
functioning properly, sparks will be visible through the vent
slots on the hou
sing. This is normal and is the action of the
brake.
OPERATION
LEVEL
TOP VIEW
Fig. 13
Fig. 14
LEVEL
END VIEW