Radio Shack Pro 84 - Manual (Page 35)

35 Beyond the Basics
Otherwise, press ./CLR if you do not want to
select it.
^
When you select the option, press ./CLR to exit
the option mode. Otherwise, to continue normal
scanning, repeatedly press FUNC until
disappears then press SCAN.
using signal stalker
To turn on Signal Stalker, turn SQUELCH fully
clockwise, then press FUNC +
once except in
WX search, band select, or program mode.
appears. Every 2 seconds, the scanner searches
for frequencies in the range you specified in “setting
the signal stalker options” on Page 33.
Note: To continue scanning normally while Signal
Stalker is working, simply press SCAN.
When the scanner finds a frequency, it sounds the
alert you specified in “setting the signal stalker
options” on Page 33, and Found flashes. Press any
key to confirm the displayed frequency. During
Signal Stalker operation, the delay time is 10
seconds. After 10 seconds have elapsed, or if you
press SCAN, the scanner resumes searching. If you
find a frequency you want to monitor continuously,
press HOLD to hold the frequency. While in hold
mode, you can select the band where you are
searching by pressing
or while appears.
F
F