RTS DKP-8 - Manual (Page 60)

54
NOTE: If you have an older chassis, you will need to attach the 3 metal tabs as shown in the figure below. You will also need
to use the supplied washer on the screw hole with no metal tab (the washer goes between the board and the chassis hole).
If you have a new chassis, you can discard the metal tabs and washer.
4. If applicable, using the supplied screws, attach the metal tabs as shown in Figure 2.
5. Using the screws from the old power supply, attach the power supply to the chassis.
NOTE: Place the washer between the new power supply and the chassis screw hole.
6. Reattach CN1 and CN2 (see figure below).
7. Replace the cover on the KP-12.
FIGURE 2. New Power Supply
FIGURE 3. New Power Supply- Installed
Metal Tab
Metal Tab
Metal Tab
Washer
Be sure to place between
the chassis and the power
supply.
NOTE:
Make sure to place
the metal tabs
exactly as shown.
CN2
CN1