Ryobi SA120 - Manual (Page 10)

Page 10
5
1
0
REVERSIBLE
See Figure 2.
This tool has the feature of being reversible. The direction of
rotation is controlled by a selector located above the switch
trigger. With the drill held in normal operating position, the
direction of rotation selector should be positioned to the left
of the switch for drilling. The drilling direction is reversed
when the selector is to the right of the switch. When the
selector is in center position, the switch trigger is locked.
CAUTION:
To prevent gear damage, always allow chuck to come
to a complete stop before changing the direction of
rotation.
To stop, release switch trigger and allow the chuck to
come to a complete stop.
ADJUSTMENTS
Fig. 2
SWITCH
TRIGGER
FORWARD
REVERSE
DIRECTION OF
ROTATION
SELECTOR
CENTER POSITION
(LOCK)
KEYLESS CHUCK
See Figure 3.
A keyless chuck has been provided with your drill to allow for
easy installation and removal of bits. As the name implies,
you can hand tighten or release drill bits in the chuck jaws.
Grasp and hold the collar of the chuck with one hand. Rotate
the chuck body with your other hand. The arrows on the
chuck indicate which direction to rotate the chuck body in
order to GRIP (tighten) or RELEASE (unlock) the drill bit.
WARNING:
Do not hold the chuck body with one hand and use
the power of the drill to tighten chuck jaws on drill
bits. Chuck body could slip in your hand or your hand
could slip and come in contact with rotating drill bit.
This could cause an accident resulting in serious per-
sonal injury.
20
Fig. 3
RELEASE (UNLOCK)
GRIP
(TIGHTEN)
CHUCK BODY
CHUCK
COLLAR