Ryobi SA120 - Manual (Page 14)

Page 14
20
5
1
0
OPERATION
Fig. 10
Fig. 9
IMPORTANT INFORMATION FOR RECHARG-
ING HOT BATTERIES
When using your drill-driver continuously, the batteries be-
come hot. You should let the batteries cool down for approxi-
mately 30 minutes before attempting to recharge.
NOTE: This situation occurs when continuous use of your
drill-driver causes the batteries to become hot. It does not
occur under normal circumstances. Refer to “Charging Your
Drill-Driver” earlier in this manual, for normal recharging of
batteries. If the charger does not charge your batteries under
normal circumstances, return both the drill-driver and charger
to your nearest authorized service center for electrical check.
For more information on the battery recycling call
1-800-8 BATTERY.
TO INSTALL BATTERY PACK
■ ■ ■ ■ ■ Place the direction of rotation selector in center posi-
tion.
See Figure 9.
■ ■ ■ ■ ■ Place the battery pack in your drill. Align raised rib on
battery pack with groove in drill's battery port.
See Fig-
ure 10.
■ ■ ■ ■ ■ Make sure the latches on each side of your battery pack
snap in place and that battery pack is secured in drill
before beginning operation.
TO REMOVE BATTERY PACK
■ ■ ■ ■ ■ Place the direction of rotation selector in center posi-
tion.
See Figure 9.
■ ■ ■ ■ ■ Locate latches on side of battery pack and depress both
sides to release battery pack from your drill.
See Figure 4.
■ ■ ■ ■ ■ Remove battery pack from your drill.
CAUTION:
When placing battery pack in your drill, be sure raised
rib on battery pack aligns with groove in drill's battery
port and latches snap in place properly. Improper
assembly of battery pack can cause damage to inter-
nal components.
SWITCH
See Figure 9.
To turn your drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
SWITCH LOCK
See Figure 9.
The switch trigger can be locked in the OFF position. This
feature helps reduce the possibility of accidental starting
when not in use. To lock the switch trigger, place the direction
of rotation selector in the center position.
DIRECTION OF
ROTATION
SELECTOR
SWITCH
TRIGGER
FORWARD
REVERSE
CENTER POSITION
(LOCK)
DEPRESS
LATCHES TO
RELEASE
BATTERY PACK
LATCHES
BATTERY
PACK
BATTERY
PORT