Roland TD-6 - Manual (Page 115)

115
Troubleshooting
Appendices
Problems Operating the TD-6
Striking Pads Does Not Switch the
Settings Screen
Is the pad’s settings screen locked?
(SETUP/MIDI COMMON/Note Chase; p. 59, p.
98)
➝ Press [INC/+] to set this to “ON.”
You can press [SHIFT] + [ ] or [ ] to switch to other
pads’ settings screens.
Song Screen Not Displayed
Is GM Mode set to “ON?”
(SETUP/MIDI COMMON/GM Mode; p. 100)
➝ Press [DEC/-] to set this to “OFF.” The sequencer does not
function when the TD-6 is in GM mode.
Cannot Record or Edit User Song
Is Song Lock set to “ON?”
(SONG/COMMON/Song Lock; p. 87)
➝ Press [DEC/-] to set this to “OFF.”
Cannot Carry Out Bulk Dump
Is the MIDI connector used to connect the MIDI
cable correct? (p. 96)
➝ If you wish to save a bulk dump on an external device,
connect the TD-6’s MIDI OUT/THRU connector to the
external sequencer’s MIDI IN connector.
Could the external MIDI device be set in such a
way as to cause it to decline the reception of
MIDI Exclusive messages?
➝ Refer to the owner’s manual for the external MIDI device,
then set it so that the reception of System Exclusive data is
enabled.
System exclusive data is data unique to individual devices,
so verify all settings.
Display Is Too Light Or Too
Dark
Is the display contrast properly adjusted?
(SETUP/UTILITY/LCD Contrast; p. 77)
➝ Press [INC/+] or [DEC/-] to make the setting.
The visibility of the display will change depending on the
viewing angle and on room lighting conditions. The
visibility of the display will change depending on the
viewing angle and on room lighting conditions.