RocketFish RF-WS01 - Manual (Page 17)

17 RF-WS01/WS01-W/WS02
Maintaining your system
Use a soft cloth dampened with a weak solution of mild detergent
and water. Dry the apparatus immediately afterwards with a clean
cloth. Do not use abrasive cloth, thinners, alcohol, or other chemical
solvents, because they may damage the finish or remove the panel
lettering.
Cautions:
• Do not cover the ventilation openings with items, such as newspapers,
table clothes, and curtains.
• If the power cord is damaged, it must be repaired by a qualified repairer.
Note:
• If the RS-WS02 becomes wet, you can drain water by gently tipping it
slightly to one side for a few seconds.
Troubleshooting
Read this User Guide carefully before using your digital wireless
speakers. Check this list for a possible troubleshooting solution
before calling for service.
Problem Solution
No sound • Make sure the sender AC adapter is connected to the sender, and either the
speaker AC adapter is connected or fresh or charged batteries are installed
in the speakers.
• Make sure that all cables are connected correctly. Check to see if the green
Link Status LEDs illuminate on the front of both the sender and speaker
units. If the green Link Status LEDs are lit solidly, the communication is
working correctly and the audio cables from audio source to the sender
should be checked. If the green Link Status LEDs are flashing or off, refer to
the “No communication between sender and speaker” section below.