Ryobi JM82 - Manual (Page 10)

10 11
ASSEMBLY
Fig. 2
UNPACKING
This product requires assembly.
n
Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
n Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
n Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
n If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Biscuit Joiner
#10 Biscuits (20)
Carrying Case
Operator’s Manual
Warranty Registration Card
WARNING:
If any parts are missing do not operate this tool until the
missing parts are replaced. Failure to do so could result
in possible serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
TO INSERT
DUST BAG
INSTALLING/REMOVING THE DUST BAG
See Figure 2.
The dust bag located on the rear of the biscuit joiner pro-
vides a dust collection system. Wood particles are drawn up
through the base and collect in the dust bag during cutting
operations. For more efficient operation, empty the dust bag
when half full.
To install, slide the dust bag adaptor onto the dust port on
the biscuit joiner. To remove the dust bag, grasp the adaptor
and pull the dust bag away from the biscuit joiner.
TO REMOVE
DUST BAG
ADAPTOR
ATTACHING THE BISCUIT JOINER TO A
VACUUM
See Figure 3.
The dust bag can be removed and a 1-1/4 in. vacuum can
be attached to the dust port.
n
Unplug the biscuit joiner.
n Remove the dust bag.
n Attach a vacuum hose to the dust port.
n Connect the biscuit joiner and the vacuum to a power
supply.
WARNING:
When the tool is not connected to vacuum, always re-
install the dust bag back onto the tool. Failure to do so
could cause dust or foreign objects to be thrown into
your face or eyes which could result in possible serious
injury.
Fig. 3