Ryobi JM82 - Manual (Page 13)

12 13
OPERATION
FENCE HEIGHT
The adjustable fence on the biscuit joiner can be moved
up or down to adjust the position of the blade in relation to
the top of the workpiece. A scale on each side of the fence
indicates the height of the fence from the center of the blade.
The fence can be positioned up to two inches from the center
of the blade. However, the scale and indicator point can only
be set up to 2 in. from the center of the blade. Scale marks
are in increments of 1/16 in.
SETTING THE FENCE HEIGHT
See Figure 7.
n
Unplug the biscuit joiner.
n Loosen the locking knob approximately one turn.
n Move the fence up or down by rotating the height adjust-
ment knob until the indicator point is aligned with the
desired dimension on the scale.
n Tighten the locking knob securely.
FENCE ANGLE
The adjustable fence on the biscuit joiner can be set at angles
ranging from 0° to 135°, with accurate positive stops set
in 45° increments. A scale is located on each side of the
adjustable fence for identifying these positive stop angles.
Each stop reached when rotating the adjustable fence from
one angle setting to another equals a 45° positive stop angle
change.
SETTING THE FENCE ANGLE
See Figure 8.
n
Unplug the biscuit joiner.
n Loosen the locking knob approximately one turn.
n Rotate the fence to the desired angle.
n Tighten the locking knob securely.
Fig. 7
Fig. 8
TO RAISE
TO LOWER
ADJUSTABLE
FENCE
ANGLE SETTING
SCALE
TO
LOOSEN
HEIGHT SETTING
SCALE
TO
TIGHTEN
INDICATOR
POINT
HEIGHT
ADJUSTMENT
KNOB
ROTATE ADJUSTABLE FENCE
TO DESIRED ANGLE SETTING
TO TIGHTEN
TO LOOSEN
LOCKING
KNOB