Radio Shack 43-3901 - Manual (Page 5)

5
Mounting the phone on a wallplate:
1. Press and lift out the handset tab. Rotate it
180°, and snap it back into place so it will
hold the handset in place when the phone is
mounted on the wall.
2. Insert the mounting bracket’s two tabs into the matching
slots on the bottom of the phone base. Press down and
slide the bracket upward until the tabs snap into place.
3. Plug one end of the supplied short phone cord into the
LINE jack on the back of the phone base.
4. Plug the cord’s other end into the wall plate jack.
5. Align the base’s keyhole slots with the wall plate studs and
slide the phone downward to secure it.
Mounting the phone directly on a wall:
To mount the phone directly on a wall, in addition to the
wallplate steps, you need two screws (not supplied) with heads
that fit into the keyhole slot on the bottom of the base.
1. Drill two holes 3 1 /
4
inches (83 mm) apart (vertically). Then
thread a screw into each hole, letting the heads extend
about 1 /
4
inch (6 mm) from the wall.
2. Place the keyhole slots over the screws, then slide the base
down until it is secure.
Tab
Mounting
bracket