RocketFish RF-WHTIB - Manual (Page 10)

10
2 If the speakers have wires instead of terminals, connect the positive (+)
wire from the right speaker to the Red (+) terminal for the right speaker
on the receiver and the negative (-) wire from the right speaker to the
Black (-) terminal for the right speaker on the receiver.
3 Connect the left speaker the same way.
Notes:
For speaker wires that have proprietary connectors, you may strip the end of the
wires to allow connection to the receiver. However, check with the speaker
manufacturer before doing this, as it may void the warranty.
Make sure the exposed tips of each cord do not touch each other, and that they are
fully inserted into the terminals.
Connecting the receiver to an AC power outlet
To connect the receiver to an AC power outlet:
1 Open cover of the cable storage compartment on the bottom of receiver,
then unwrap the cable and extend it to the desired length.
2 Close the cover and make sure that the extended cable is not pinched
and comes out from the power cord hole as shown in the diagram.
3 Plug the AC power plug into a power outlet.
Power cord hole
Plug the AC
power cord in
only after all
speakers are
connected to
the receiver.