RocketFish RF-WHTIB - Manual (Page 13)

13 RF-WHTIB
The volume control on the receiver is only used to adjust the balance
of the volume between the front and rear speakers. After the system
is set up, we recommend that you adjust the volume balance one
time.
To adjust the volume balance:
1 Turn on the sender and receiver, then turn on the amplifier and adjust it
to your normal listening level.
2 Adjust the volume on the receiver, using the volume control knob, to
balance the front and rear speakers.
After the volume of the receiver is set up, always adjust the volume using
the volume control on your amplifier whenever needed.
To turn off the system:
1 Press and hold the (power) button on the sender for two seconds. The
LED indicator will blink quickly first and then go off to indicate that the
sender is turned off.
2 Press and hold the (power) button on the receiver for two seconds.
The LED indicator will blink quickly first and then go off to indicate that
the receiver is turned off.
Note:
You can leave both units on when not in use.
Optimizing your surround sound
The RocketFish Universal Wireless Rear Speaker Kit uses
state-of-the-art 2.4 GHz technology to digitally send audio data from
the sender to the receiver. Wireless links create a small latency
between the sender and receiver, and many A/V receivers let you
adjust the delay between the various speakers in your surround
system. To optimize your system when tuning your speaker setup,
we suggest that you shorten the delay to the rear speakers by
15-20 ms.