Rockford Fosgate RFX9220M - Manual (Page 17)

17
O
PERATION
– CD P
LAYER
RFX 8620M CD Changer Operation (Optional Accessory)
Magazine Eject
1. Slide door open in the direction shown.
2. Press the EJECT button to release the disc
magazine from the CD changer.
NOTE: The panel will display NO CD, if in CDX mode,
then go to AUX1 mode.
NOTE: If the front eject button does not work, a manual
eject lever is visible through a hole at the bottom
of the unit. Move the lever in the direction
shown to eject magazine.
Loading Disc to the Magazine
1. Pull out the desired disc tray number from the
magazine.
2. Place the disc into the magazine, label side up.
3. Push the disc tray back into the magazine.
NOTE: Discs numbers are arranged from the bottom
up.
Loading the Magazine to the CD Changer
The INSERT IN THIS DIRECTION arrow indicates the
proper direction that the magazine should be loaded into
the CD changer.
CAUTION: Avoid installing or leaving the
magazine where it would be subject to high temperatures such as from direct
sunlight or from hot air from the heater. Doing so will damage the unit.
CD Changer Mode
1. Press the MODE button until CDX PLAY is displayed.
2. The CD changer will immediately begin playing track #1 of the first available disc.
3. If the changer was previously initialized, the changer will resume playing the last
track initialized.
Disc Selection
1. Press the PRESET 5–UP button to select the next disc in the magazine.
2. Press the PRESET 4–DOWN button to select the previous disc in the
magazine.
3. Press the D-ACC button and numbers 1-8 for direct disc access.
Panel Display
While playing a disc the panel will display the track number and the time played, also
the disc number, unless the default has been change to TITLE DEFAULT and a disc
title has been programmed in. See PANEL DISPLAY DEFAULT in
OPERATION-BASIC.
NOTE: When the last track # on the current disc is reached, the next disc will load and begin playing track
#1.
6
5
4
3
2
1
PUSH
Eject Manual Eject
Label
Side Up
Slide Door