Radio Shack Auvio 40-290 - Manual (Page 3)



1. Remove the inner cardboard disc from
the supplied template/paint mask and
keep it for later. Use the outer portion
of the mask as a template to mark
the cutout hole size and location for
mounting the speaker.
. Use a drywall or keyhole saw to cut
the hole.
2
Connect to your amplifier
1. Route the speaker wire from your amplifier to the
speaker. Avoid routing near existing electrical wires and
do not nail or staple the wire.
. Separate about 4 inches (100
mm) of wire at each end.
. Using a wire stripper, remove
about 1 /
4
inch (6 mm) of
insulation from each wire. Then
twist the ends of each wire.
4. Connect the positive (marked) wire to the red speaker
terminal by pressing the tab, inserting the wire into the hole,
and releasing the tab. Repeat this procedure to connect the
negative (unmarked) wire to the black terminal.
6. Connect the wire coming from the red terminal to your
amplifier’s positive (+) terminal. Connect the wire from
the black terminal to your amplifier’s negative (–) terminal.
Template
AM LOOP FM UNBAL 75 Ω ANTENNA
FRONT R L CENTER SURROUND S
K
E
R
S
R L
S-VIDEO cable Coaxial digital cable
Composite Video Cables Audio Cables Component Video Cables
SPEAKERS
Tabs Screw
4 inches
1 /
4
inch
4 inches
1 /
4
inch