Before you call for service – Rheem GG Series User Manual

Page 23

Advertising
background image

23

Problem

Possible Causes

What To Do

Condensation

This usually happens when

This is normal. After the water in the tank warms

a new water heater is

up the condensation will disappear. If, however, the

filled for the first time.

condition persists, examine the piping and fittings
for possible leaks.

Moisture from the products

This is normal and will disappear in time. Excessive

of combustion condensing

condensation can cause pilot outage.

on the tank surface.

An undersized water

Use a water heater size that meets the requirements

heater will cause

of your needs.

condensation.

Yellow flame

Scale on top of the burner.

Shut off the water heater and remove scale.

or sooting

Combustion air inlets or

Remove lint or debris and inspect air inlet opening

flue-way restricted.

for restriction.

Not enough combustion or

Proper operation of the water heater requires air for

ventilation air supplied to

combustion and ventilation. See the Combustion and

the water heater location.

Ventilation Air information in the Locating the water
heater section of this manual.

Unable to light

Gas Cock Knob not

See the Lighting the water heater section of this

the pilot

correctly positioned.

manual.

Pilot orifice clogged.

The pilot should be cleaned or replaced by a qualified
service technician.

Pilot tube pinched or

The pilot should be cleaned, repaired or replaced by a

clogged.

qualified service technician.

Air in gas line.

Contact a qualified service technician to purge the air
from the gas line.

Pilot does not stay

Loose thermocouple.

The connection at the gas control (thermostat) should

lit when the RED

be tightened by a qualified service technician.

button is released

Thermocouple breakdown.

The thermocouple should be replaced by a qualified
service technician.

Safety magnet breakdown.

The gas control (thermostat) should be replaced by a
qualified service technician.

Thermostat’s single

The gas control (thermostat) should be replaced by a

use gas shut-off device

qualified service technician.

has opened.

CAUTION: For your safety DO NOT attempt repair of gas piping, gas control (thermostat), burners, vent

connectors or other safety devices. Refer repairs to qualified service personnel.

Before You Call For Service…

Troubleshooting Tips
Save time and money! Review the charts on
the following pages first and you may not
need to call for service.

Safety Instructions

Installation Instructions

Operating Instructions

Care and Cleaning

T

roubleshooting Tips

Customer Service

Advertising