RadioLAN Campus BridgeLINK - Manual (Page 27)

890-007 Rev. A 01/28/99 Page 17 © 1999 RadioLAN, Inc.
Mounting the CPU
When mounting the CPU, you must follow these steps.
Before mounting the CPU to the mounting surface,
connect the connector at the end of the CRM’s cable to
the 15 pin D connector on the CPU (see Figure 13).
Route the antenna cable from the directional antenna to
the CRM, and slip the cold-shrink tubing over the end of
the cable before connecting the cable to the antenna.
Connect the cable to the CRM, using a clockwise rotation.
Tighten the antenna connector so that it is snug but does
not strip the threads of the connector on the CRM.
Complete the shrink tubing installation by following the
instructions provided with the tubing.
Figure 13: Connecting the Antenna Cable to
the CRM