Operation, Setting the beep, Loading a cassette tape – Roberts Radio TCR-200 User Manual
Page 8: Recording a phone conversation
8
OPERATION
SETTING THE BEEP
You can set the telephone cassette re-
corder to beep every 15 seconds while
recording.
Note: You might be legally required to
set
BEEP TONE
to
ON
when recording,
so all parties know the conversation is
being recorded. Check the laws in your
area.
1. Remove the battery compartment
cover and remove the batteries, if
installed.
2. Set
BEEP TONE
to
ON
. The tele-
phone cassette recorder beeps ev-
ery 15 seconds while recording.
3. Replace the batteries and the cover.
LOADING A CASSETTE
TAPE
Follow these steps to install a cassette
tape (not supplied) in the recorder.
1. Turn the cassette’s hub with a pencil
to take up any tape slack.
2. Press
STOP/EJECT
to open the cas-
sette compartment door. Put the
cassette in the compartment with
the cassette’s open edge facing you
and the full reel on the left.
3. Close the door.
Notes:
• You can buy cassettes of varying
lengths at your local RadioShack
store.
• Replace the tape at least once a
year, or more often if it is used
heavily.
RECORDING A PHONE
CONVERSATION
You can record both sides of a conver-
sation on any phone connected to the
same phone line as the recorder.
1. Set
REC MODE
, the sensitivity level,
SPEED
, and
MONITOR
to the desired
settings. (See “Setting the Record
Mode” on Page 9, “Setting the Sen-
sitivity Level” on Page 9, “Setting
the Recording Speed” on Page 10,
and “Listening While You Record”
on Page 10.)
ALWAYS DISCONNECT ALL TELEPHONE
LINES FROM THE WALL OUTLETS BEFORE
SERVICING OR DISASSEMBLING THIS
EQUIPMENT, OR REPLACING BATTERIES.
---
+
ON OFF
BEEP TONE
---
+
---
+
---
+
DC 6V
(UM/SUM-3) X4
MIC
VU
LEVE
L
43-473.fm Page 8 Friday, August 13, 1999 9:21 AM