AEG ELECTROLUX F 65000 VI 1 P - Manual (Page 40)

Problem Possible cause Possible solution
The quantity of detergent
was too much. Make sure that you add the
correct quantity of detergent
in the dispenser before you
start a programme.
Dry water drop
stains on glasses
and dishes. The released quantity of
rinse aid was not sufficient . Increase the released quanti-
ty of rinse aid.
The quality of the detergent
can be the cause. Try a different brand of de-
tergent.
The dishes are wet. • The programme had no
drying phase.
• The programme had a
low temperature drying
phase.
For better drying results,
keep the door ajar for some
minutes.
The dishes are wet
and matt. The rinse aid dispenser is
empty. Make sure that there is rinse
aid in the rinse aid dispenser.
The quality of the rinse aid
can be the cause. Try a different brand of rinse
aid.
The quality of the combi
detergent tablets can be
the cause. • Try a different brand of
combi detergent tablets.
• Activate the rinse aid dis-
penser and use the rinse
aid together with the com-
bi detergent tablets.
Activating the rinse aid
dispenser with the multitab
function activated
1. Press the on/off button to activate
the appliance.
2. Make sure that the appliance is in
setting mode. Refer to ‘SETTING
AND STARTING A PROGRAMME’.
3. Press and hold buttons (4) and (5) at
the same time until the indicators of
buttons (3), (4) and (5) flash.
4. Press button (4).
• The indicators of buttons (3) and
(5) go off.
• The indicator of button (4) contin-
ues to flash.
• The display shows the setting of
the rinse aid dispenser.
Off
On
5. Press button (4) to change the set-
ting.
6. Deactivate the appliance to confirm.
7. Adjust the released quantity of rinse
aid.
8. Fill the rinse aid dispenser.
TECHNICAL INFORMATION
Dimensions Width / Height / Depth (mm) 596 / 818 - 898 / 550
Electrical connection Refer to the rating plate.
Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )
40