Range Kleen PSC484GG - Manual (Page 19)

Section Four: Using the Cooktop
Page 17
USING THE GRILL
Exploded Views and Side View of Grill
Burner Placement in slots in back of grill
Heat
Deflector
Grill Box
Drip Pan
U-shaped
burner
Grill
Grate
Stainless
Steel Radiant
Spark igniter
After removing all packaging materials, check to be
certain that the grill components are correctly assembled
in the grill box. The grill grates, stainless steel radiant
and the burner are assembled in the grill box from the
factory. Follow the steps below to assemble the com-
ponents in the grill box.
A. Disassemble and/or remove the grill grate, stainless
steel radiant and burner from the grill box.
B. Install the aluminum rectangular drip pan inside the
grill box as shown below.
C. Install the heat deflector on grease drip pan handle
and pins in front of the box.
D. Insert the end of the burner into the slots at the
back of the grill box. Insert the tab on front of the
burner into slot in the heat deflector.
E. The stainless steel radiant lies on two (2) studs on
each end of the grill can.
F. Place the grill grate, with raised food containment
rail oriented towards the grill box rear.
CAUTION:
• Use extreme care when placing the grill
components into the grill compartment.
Avoid contacting the ceramic igniter
which could break preventing operation
of the grill.
• The grill must be assembled as shown.
The drip tray heat shields must be in
place, and the burner must be properly
positioned relative to the gas supply.
Incorrect assembly of the grill may result
in unsafe or hazardous conditions during
operation.
• Do not leave the grill unattended while
in use.
• Do not use charcoal briquettes or coals
of any kind.