Rose electronic Vista Mini User Manual
Page 14
when holding a key down to repeat the key, such as when moving a cursor
across a line. The rate is the speed at which the keys are sent in keys/second.
The delay is the wait time in milliseconds after the key is initially pressed, before
additional keystrokes are sent. To issue the command press and release the
left Control key, then type “A”, then enter the 1-3 digit decimal typematic value
followed by <Enter>. The typematic value is defined as shown below. Use the
keep command to save the value.
The typematic value to be used is determined from the following tables using the
equation: Typematic Value = Rate value + Delay Value. Pick the desired rate
in keys/sec. (32 choices) and delay in milliseconds (4 choices) from the tables
below. Add the values to the right of the desired settings. For example to use a
Rate of 16.0 keys/sec. and a 500 millisecond delay, the typematic value = 7 +
32 = 39, so to set this value, type <Ctrl> A 39 <Enter>.
Table 4. Typematic rate
Rate
Keys/sec
Rate
Value
Rate
Keys/sec
Rate
Value
Rate
Keys/sec
Rate
Value
Rate
Keys/sec
Rate
Value
30.0
0
15.0
8
7.5
16
3.7
24
26.7
1
13.3
9
6.7
17
3.3
25
24.0
2
12.0
10
6.0
18
3.0
26
21.8
3
10.9
11
5.5
19
2.7
27
20.0
4
10.0
12
5.0
20
2.5
28
18.5
5
9.2
13
4.6
21
2.3
29
17.1
6
8.6
14
4.3
22
2.1
30
16.0
7
8.0
15
4.0
23
2.0
31
Table 5. Typematic delay
Delay in
millisec.
Delay
value
Delay in
millisec.
Delay
value
Delay in
millisec.
Delay
value
Delay in
millisec.
Delay
value
250
0
500
32
750
64
1000
96
10
VIStA MINI INSTALLATION AND OPERATION MANUAL