Rose electronic Vista Mini - Manual (Page 18)

KEYBOARD COMMAND SUMMARY
To enter any keyboard command, first press and release the left Control Key,
represented by <Ctrl>. Then enter the command followed by any parameters
you wish to specify, for example the computer number.
Letter commands are not case sensitive, and are shown in upper case for clarity
only.
Do not use the numeric keypad to enter any commands.
All Vista Mini commands use a two second time-out between characters, to
abort the command. This is a feature that restores the keyboard to normal oper-
ation, so the keyboard is not put it into a command mode which might lock it up
from normal operation.
The <Ctrl> character is always passed through to the CPU. The command
characters and command operands, however, are absorbed by the Vista Mini
and not sent to the CPU.
Table 6. Keyboard command summary
Command Key Sequence Description
Connect to
computer
<Ctrl> x
where x is 1, or 2
Connects your common keyboard, monitor,
and mouse to the selected computer.
Connect to
next com-
puter
<Ctrl> + Selects the other computer.
Connect to
previous
computer
<Ctrl> - Selects the other computer
Scan On <Ctrl> S Turns Scan mode on, causing Vista Mini to
start scanning sequentially from the current
port through the remaining ports and begin-
ning again at Port 1.
Scan Off <Ctrl> X Turns Scan mode off.
Note: Scan can also be stopped by entering
a port selection command.
14 VIStA MINI INSTALLATION AND OPERATION MANUAL