Roberts Radio DreamTime2 - Manual (Page 5)

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
4
Using the clock radio for the fi rst time
1. Place your clock radio on a fl at surface.
2. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
3. Insert the adaptor plug into the DC socket located on the rear of your
clock radio. Plug the adaptor into a standard 13 amp mains socket
outlet. The display will show 'ROBERTS' for a few seconds and will
then show 'SET CLOCK'. During this time the radio is scanning to fi nd
a DAB radio signal. After a short time the current time and day will
appear on the display.
4. If no signal is found, 'NO CLOCK' will be displayed. It may be necessary
to relocate your clock radio to a position giving better reception. You
should then carry out a scan to fi nd stations as described on page 9.
IMPORTANT: The mains adaptor is used as the means of connecting
the clock radio to the mains supply. The mains socket used for the clock
radio must remain accessible during normal use. In order to disconnect
the clock radio from the mains completely, the mains adaptor should be
removed from the mains socket outlet completely.
Characters appearing on the LCD display indicate that the clock radio is
connected to and powered from the mains supply.
DC 7.5V