Raymarine GPS Plotter - Manual (Page 72)

Chapter 3: Operation 3-43
Naming, Erasing and Showing a Track
➤
To name an existing track, erase a track or show a track:
1. Press the TRACK LIST soft key; the Track List is displayed.
The highlight indicates the selected track.
2. Using the trackpad top/bottom, select the required track and press the
SAVE TRACK, NAME TRACK or ERASE TRACK soft key.
3. To NAME a track, use the trackpad left/right to select the character you
wish to edit and the trackpad top/bottom to change the character.
4. Press ENTER to finish the operation or CLEAR to cancel the name.
5. To ERASE a track you are prompted to confirm:
i. Press NO to cancel the operation, then ENTER if you wish to
remove the Track List.
ii. Press YES to erase the track from the Track List, then ENTER to
remove the Track List.
6. If you select SHOW a track when a current, unsaved track is displayed,
you are prompted to save the current track. Proceed as described in
Clearing the Current Track on page 3-41 or press the NO soft key to
cancel the operation.
The Track List is removed and the selected track is displayed.
81171_4.BOOK Page 43 Thursday, November 29, 2001 11:34 AM