Ricoh A251 - Manual (Page 116)

31
PARTIAL COPYING
The Partial Copy function copies only a part of an original.
You need to enter start and end points in the original feed direction.
Notes
❐ You cannot use the Partial Copying function using the Rear Table.
❐ You cannot use the Partial Copying function for originals shorter than 255 mm.
❐ If you set the start point within 155 mm from the leading edge of the original, the copier will
regard the leading edge as the start point.
❐ The minimum available space between the start point and the end point is 30 mm.
❐ If you do not set the end point after setting the start point, the copier will regard the trailing edge
of the original as the end point.
❐ If you set the start point within 40 mm from the trailing edge of the original, the copier will cancel
the copying and exit the original.
❐ If you set the end point within 40 mm from the trailing edge of the original, the copier will regard
the trailing edge as the end point.
❐ In the Synchro Cutting function, the copier will cut the paper in a length from the start point to the
end point.
❐ When selecting the Partial Copying function, the copier will reset the settings for the trailing edge
margin, the leading edge margin in the Synchro Cutting function, and the Repeated Copying
function.
1 Hold down the Function Select key for three
seconds.
A “P” will blink in the copy counter display. Paper Length
Synchro
Preset/
Variable
Leading Edge
Trailing Edge
Copy Counter
Function Select
Bypass Select/
Roll Paper Cut
Cut Select
Preset Cut
a
b
original Bypass Table
Preset/Variable Cut Mode
Synchro Cut Mode