Ricoh A251 - Manual (Page 22)

13
BASIC COPYING (COPYING TO SHEETS)
Use the Copy Paper Table to copy onto paper.
Notes
❐ For acceptable types of original and paper see ⇒
page 8 and 10.
❐ Set one sheet of paper at a time on the Copy Paper Table. Never insert more than one sheet of
paper.
❐ If the copy paper is curled, set it with curl facing downwards.
❐ When you set A0 size(36”
×
48”) paper, to make sure the ends do not touch the floor and get dirty,
lay a wide piece of paper or some other covering on the floor.
❐ Do not use the paper which is cut obliquely, when the difference between the right side and the left
side of the paper is more than 5mm (4/5”), creasing or a paper jam might occur.
❐ You cannot copy to both sides of the paper at a time.
❐ It takes about 5 minutes until you can start copying after you turn the copier on. The machine is
warming up when the “Wait” indicator is lit, but you can still edit settings, insert copy paper or
insert your original.
❐ You can set either paper or an original first. When you have set both of them, the copier starts
copying automatically.
❐ Do not lean on the copy table or lay heavy objects on it.
2. COPYING
CAUTION : If during copying your original gets stuck in the copier, press the
Emergency Stop key.
If you stop the operation by pressing this key, remove both the
original and paper.