Ritek QuattroDrive - Manual (Page 22)

Switching between Flash Memory Cards and a CD
18
DISC SETUP
This page is used to set various CD-RW functions for burning (writing) a CD.
ERASE CD-RW is used to
erase a CD-RW before burning.
MODE SELECT has three op-
tions.
WRITE MODE – burns to the
CD.
TEST MODE – simulates a burn
to the CD but does not actually
perform an actual burn.
VERIFY MODE – burns to the
CD and then verifies the data.
Switching between Flash Memory Cards and a CD
There a two ways to switch between a Flash Memory Card and a CD.
Using the Remote Control
This method is normally used when the QuattroDrive is connected to a TV or a
projector.
Press the MODE button on the remote control. The GOTO button can also be
used.
The OSD will display FLASH CARD or DISC LOADING in the top left corner.
Using the Buttons on the QuattroDrive
This method is used for when you are on the road and a TV or projector is not
available.
1.
Press the STOP/ESC button on the QuattroDrive to bring up the menu in
the LCD panel.
2. Press the PREV and NEXT buttons to switch
between CArd, dISC, COPY or ErASE.
3. Press the ENTER/PLAY button to switch to the
desired media storage type, copy files to a
CD-R/W or erasing a CD-RW. See Writing (Burn-
ing) Files to a CD on page 26 for details on the
copy and erase functions.
MODE
PAUSE PBC ZOOM AUDIO
ANGLE TITLE OSD
MODE