Ritek QuattroDrive - Manual (Page 31)

Using QuattroDrive
27
4. Press COPY on the remote control to start burning files to the CD.
5. Wait until the COPY COMPLETED message appears on the screen and
the CD-R/W LED stops flashing before removing the CD.
When the QuattroDrive is not connected to a TV/projector, follow the steps be-
low.
1.
Insert the Flash Memory Card as described in Inserting Flash Memory
Cards on page 6.
2. Insert a CD-RW or a blank CD-R into the QuattroDrive as described in
Inserting and Removing a CD on page 6.
3. Press the STOP/ESC button on the QuattroDrive to bring up the menu in
the LCD panel.
4. Press the PREV and NEXT buttons until COPy appears in the LCD panel.
5. Press the ENTER/PLAY button to begin copying to the CD-RW. A number
will appear showing the percent left to be copied as shown in the diagram.
Wait until the End message or an error message (see Error Codes on
page 29) appears before continuing.
6. Press the STOP/ESC button to get back to the main menu and again to
exit.
NOTE: Ensure that MODE SELECT is not set to TEST MODE as described in
DISC SETUP on page 18, before disconnecting from the TV/projector,
otherwise files will not be burnt to the CD-R/W.
Files are placed in a directory called DMX with a consecutive number following.
For example, files from your first burn will be placed in a directory called DMX01,
files from your second burn will be placed in a directory called DMX02 and so
on.
COPY
ENTER
MUTE STOP
PLAY
COPY
%left
DUP