RCA RS-1247 - Manual (Page 17)

17
using the cassette decks
R
ECORDING FROM THE
CD P
LAYER
1. Follow steps 1 and 2 of the previous section on RECORDING FROM
RADIO.
2. Select CD Player mode by pressing FUNCTION repeatedly until the
display shows “CD”.
3. Load one to three CDs into the CD compartment tray, press 1-2-3 DISC
to select the desired disc, then press or to select the
desired first track you want to record.
4. Quicky press PLAY/PAUSE twice to pause CD, avoiding immediate CD
play.
5. At deck 1, press PAUSE then press RECORD.
6. Now...get ready to release both pauses! Put a finger of one hand on
the CD player’s PLAY/PAUSE and put a finger of the other hand on the
deck 1’s PAUSE. Press on both simultaneously to begin recording.
R
ECORDING FROM A
C
ASSETTE
T
APE
1. Follow steps 1 and 2 of the previous section on RECORDING FROM
RADIO.
2. Load the pre-recorded tape into deck 2 (this should be the tape that
you want to record from).
3. Select Tape mode by pressing FUNCTION repeatedly until the display
shows “TAPE”.
4. At deck 1, press PAUSE then press RECORD.
5. To begin recording, press PLAY at deck 2 and the system automatically
releases the Pause on deck 1.
6. To put a pause in the recording, press PAUSE at deck 1. To resume
recording, press PAUSE again.
DON’T INFRINGE !
This product should only be used for the purposes for which it is sold,
that is, entertainment, violating no copyright law. Any attempts to use
this product for which it is not intended is unlawful and therefore not
condoned by Thomson Consumer Electronics.