RCA RS-1247 - Manual (Page 18)

using the Remote control
POWER
TUNER CD TAPE
PAUSE
TRACK TRACK STOP
REPEAT DISC SKIP SHUFFLE
RECORD
TUNING
DEMO
VOL VOL
PLAY
PRESET SEEK
SUPER
BASS
M UTE
PRE
SET EQ
installing batteries
The remote control must be inserted with 2
AAA batteries prior use. Follow the steps
below to ensure correct installation.
1. Fit the tip of your index finger into A ,
slightly push the tab of the battery
compartment lid towards direction
B ,
lightly lift upwards to detach the lid.
2. Before inserting the batteries, observe
the polarities (that is,
+
and
-
) of the
batteries, then relate the polarities to the
engraved diagram inside the battery
compartment. Now insert the batteries.
3. After installation of the batteries, replace and
fit the lid to cover the batteries. Lightly push it
close.You should hear a small “CLICK” sound
from the closing of the tab.
remote control operations
1. Press POWER to turn on system.
2. To select one of the available modes: Tuner,
CD or Tape, press TUNER or CD or TAPE.
Note: The RECORD button on the
remote control is inactive for this model.
3. To see a display demonstration of the
system, press DEMO.
4. To turn off system, press POWER again.
F
OR
S
OUND
E
FFECT AND
V
OLUME
A
DJUSTMENTS
1. Press SUPER BASS to enhance heavy-
based sound.
2. To select one of the five preset sound
effects, press PRESET EQ repeatedly to
toggle between the five Preset EQ (Preset
Equalizers): Jazz, Rock, Classical, Techno,
Flat.
3. Press MUTE to silence the sound output.
Resume to normal by pressing MUTE
again.
4. Adjust the sound output level by pressing
VOL
+
to increase or VOL
-
to decrease.
18
A
B