Ryobi BGH827 - Manual (Page 11)

11
MOUNTING SAFETY SHIELD ASSEMBLY
See Figure 5.
n
Fasten the safety shield assemblies to the safety shield
brackets using the fastening knob and small washer.
NOTE: The slotted part of the safety shield bracket must
face towards the grinding wheel guard.
n Attach the safety shield assembly and bracket to the
wheel guard using a washer, lock washer and rear shield
bracket knob.
WARNING:
Always spin the wheel by hand before turning on the
grinder to make sure the spark deflector doesn’t hit the
grinding wheel.
ASSEMBLY
UNPACKING
This product requires assembly.
n
Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
n Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
n Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
n If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are missing do not operate this tool until the
missing parts are replaced. Failure to do so could result
in possible serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
WARNING:
Always disconnect the bench grinder from the power
source before performing any assembly. Failure to do so
could result in accidental starting resulting in possible
serious personal injury.
LOCK
WASHER
Fig. 5
SAFETY SHIELD
(RIGHT)
WASHER
SHIELD BRACKET
(RIGHT)
SMALL
KNOB
REAR SHIELD
BRACKET KNOB
SMALL
WASHER