RIDGID R8408 - Manual (Page 21)


OPERATION
FOR NON-DOCKING iPods, OTHER MP3 PLAYERS,
AND CD PLAYERS:
 Select AUX 2 MODE.
 Open the drop-down compartment door by pulling up on
the latch handle.
 Make sure the iPod/MP3 player will fit inside the
compartment provided.
NOTE: CD players will not fit.
 The retainer strap may be used to secure the iPod/MP3
player into position.
CD players can simply be placed on the foam padding on
the inside of the compartment door. The compartment
door cannot be closed when a CD player is connected.
 Connect one end of a 3.5 mm audio patch cord (maximum
8 in. long) to the iPod/MP3/CD player.
 Connect the other end of the 3.5 mm patch cord to the
AUX 2 jack provided.
 Make sure that the audio patch cable is positioned so
that it is not pinched if the door is closed.
 The iPod/MP3/CD player must be ON and in PLAY mode
for sound to be heard through the speakers.
 All iPod/MP3/CD player controls can be used normally
while connected to radio.
NOTE: Volume for any device connected through the
AUX 2 jack is adjusted using the volume control for that
device.
 Turning the radio OFF will NOT turn the iPod/MP3 player
OFF.
 To protect the iPod/MP3 player from environmental
hazards such as dust, moisture, etc., the drop-down
compartment door must be closed and latched.
 The AUX 2 jack DOES NOT provide charging function.
 For complete operating instructions for all iPod, other
MP3 players, and CD players, always refer to the manual
that was included with your model.
 Most CD players are too large to fit inside the internal
compartment. To use these devices, open the drop-down
compartment door to access the
AUX 2 input jack, and
connect the device as described above. Turn on the CD
player and adjust the volume to the desired level.
Fig. 4
iPod OR OTHER
MP3 PLAYER
3.5 mm AUDIO
PATCH CABLE
(INCLUDED)
LCD DISPLAYS
AUX 2 MODE
RETAINER
STRAP