Operation – Ryobi RY09951 User Manual

Page 11

Advertising
background image

9 - English

OPERATION

PRIME - Press the primer bulb 7 times.

SET the start lever to the START position.

PULL the starter grip until the engine starts.

NOTE: Squeezing and releasing the throttle trigger releases
the start lever to the

RUN position.

To start a warm engine:
PULL
the starter grip until the engine starts.

To stop the engine:
Press and hold the switch in the stop “ ” position until
the engine stops.

OPERATING THE BLOWER

See Figures 8 - 9.

WARNING:

Never run the unit without the blower tubes installed or

the vacuum door securely closed. Use of an improperly
assembled unit could result in serious personal injury.

Start the blower. Refer to

Starting and Stopping earlier

in this manual. Hold the blower with the upper handle in
your right hand.

WARNING:

Always hold the blower away from your body with the
handle in your right hand when operating as a blower,
keeping clearance between your body and the product.
The muffler side of the blower should be away from your
body. Any contact with the housing can result in burns
and/or other serious personal injury.

WARNING:

Do not place blower on top of or near loose debris or
gravel. Debris may be sucked into blower intake vent
resulting in possible damage to the unit and could result
in serious personal injury.

To keep from scattering debris, blow around the outer

edges of a debris pile. Never blow directly into the center
of a pile.

Operate power equipment at reasonable hours only - not

early in the morning or late at night when people might
be disturbed. Comply with the times listed in local ordi-
nances.

To reduce sound levels, limit the number of pieces of

equipment used at any one time.

Conserve water by using power blowers instead of hoses

for many lawn and garden applications, including areas
such as gutters, screens, patios, grills, porches, and
gardens.

Operate blower at the lowest possible throttle speed to

do the job.

Check your equipment before operation, especially the

muffler, air intakes, and air filters.

Use rakes and brooms to loosen debris before blowing.

In dusty conditions, slightly dampen surfaces when water

is available.

Watch out for children, pets, open windows, or freshly

washed cars, and blow debris safely away.

Hold blower, as shown in Figure 9, so the air stream can

work close to the ground.

After using blowers or other equipment, CLEAN UP!

Dispose of debris properly.

Use the sweeper nozzle for the everyday blowing opera-

tion. This nozzle allows for more area to be covered during
the blowing operation.

The high velocity nozzle is specifically designed for wet

sticky leaves. It allows you to scrape wet leaves or debris
while operating the blower.

CRUISE CONTROL

See Figure 10.
The cruise control can be used to operate the blower without
holding the throttle trigger.
To engage the cruise control:

Pull cruise control lever back towards user, and stop at

the desired throttle setting.

To release the cruise control, push cruise control lever all

the way towards the front of unit.

VACUUM OPERATION

See Figure 11.

WARNING:

Never run the unit without the vacuum tubes and vacuum
bag installed. Use of an improperly assembled unit could
result in serious personal injury.

WARNING:

Keep the muffler and all hot surfaces of the blower/vacuum
away from your body. Failure to do so could result in
possible serious personal injury.

Install the vacuum tubes and the bag. Refer to the AS-

Sembly section earlier in this manual.

Start the blower. Refer to

Starting and Stopping earlier

in this manual.

Place the vacuum bag strap over your right shoulder.

Hold the upper handle in your left hand and the vacuum
handle in your right hand.

Advertising
This manual is related to the following products: