Chapter 3 using the panel pc, 1 introduction, 2 floppy drive – Ricoh PPC-154 User Manual
Page 28: Figure 3.1: inserting and ejecting a floppy disk, Chapter, 3 using the panel pc, Introduction, Floppy drive, Figure 3.1:inserting and ejecting a floppy disk
PPC-154 User’s Manual
20
Chapter 3 Using the Panel PC
3.1 Introduction
This chapter describes basic features and procedures for using the panel
PC. Topics covered include the floppy drive, CD-ROM drive, I/O ports,
touchscreen, and so on..
3.2 Floppy drive
To insert a floppy disk, hold it with your right hand, between your thumb
and your other fingers, and push it toward the drive. (See Fig. 3-1.)
Slide the disk until it clicks into place.
To eject a floppy disk, first make sure that the drive activity light is off,
and then press the eject button on the drive. When the disk pops out of the
drive, remove it and store it properly.
Figure 3.1: Inserting and ejecting a floppy disk
Note:
New disks must be formatted by your operating sys-
tem before you can use them for data storage. See
your operating system manual for details.