Rogue Audio M-150 User Manual
Page 4
3
CONNECTING M150 TO YOUR SYSTEM
Connecting M150 to the Loudspeakers:
The rear panel has binding posts for both 4 and 8 ohm loudspeakers as shown in
Figure 1. In general, if your speakers are rated at less than 6 ohms, use the 4 ohm
taps and use the 8 ohm taps if they are 6 ohms or greater.
CAUTION – Do not operate the amplifier unless it is connected to a
loudspeaker.
Connecting M150 to the preamplifier:
There are two types of input connections on the rear panel of M150:
1) Fully balanced XLR type input.
2) RCA input
The input connections can be made using either the XLR or RCA input,
depending on your system setup.
Note that if you have a variable output CD player you can drive the M150 with it
directly.
Figure 1. Rear panel layout
4 Ohm Tap
8 Ohm Tap
XLR Input
RCA Input
Ultra Linear/
Triode Switch
Ground Lift
Switch
Power In
Main Fuse