Rogue Audio M-150 - Manual (Page 6)

5
Triode/Ultralinear switch:
This switch is located on the back panel of the amp. See Figure 1. The output
transformer of a tube amplifier acts as the electrical interface between the very
different impedances of the loudspeaker and the tube circuitry. There are three
fundamental ways that the output transformer can be connected to the tube circuit.
1) Tetrode or Pentode connection – In this configuration, the highest power level
is achieved but at the expense of significantly higher distortion levels.
Practically speaking, this mode of operation is sonically inferior and has been
disregarded in the M150 design.
2) Triode connection – With this configuration, the lowest level of distortion is
achieved but at the expense of output power. In the case of the M150, its
power level in triode is high enough that it will likely provide plenty of power
for almost any speaker load.
3) Ultralinear operation – With this configuration, power levels near those of
tetrode mode are achieved with low distortion levels that approach those of
triode operation. For loudspeakers that demand very high levels of power,
ultralinear should provide excellent sound and plenty of power.
The triode/ultralinear switch allows the user to operate M150 in either of the two
modes. In general, the sonic differences are subtle but for a given loudspeaker one
mode is likely to sound better than the other. There is a complex relationship
between the output transformer and the crossover network so try both and see
which one works best in your system. This switch can be operated while the
amplifier is playing but you will hear a small relay noise through the loudspeaker.
SETTING THE TUBE BIAS
Tools required: bias tool (provided with amplifier)
The output tubes (the big ones) need to be “biased’ with a grid voltage that
controls the flow of electrical current through the tube. Tube biasing on the M150
amplifier has been designed to be both simple and effective. On some amplifiers
biasing is done for two or more tubes simultaneously. With this method, the total
current flowing through the group of tubes may be correct, but the current flow
through any individual tube may vary significantly from the optimal value. With
the M150 amplifier the bias is set individually for each tube so that the correct
operating point is assured. An added benefit to this approach is that, should a
tube fail prematurely, the single tube can be replaced without having to purchase a
matched set. Use the following procedure to set the tube bias: