4 connections to the plasmawall and dhd controller, Connecting the plasmawall to the dhd controller, Connections to the plasmawall and dhd controller – Runco SP-60DHD User Manual
Page 33: 3. connecting the plasmawall to the dhd controller, Pre l iminar y
PlasmaWall SP Series Owner’s Operating Manual
23
PRE
L
IMINAR
Y
3.4
Connections to the
PlasmaWall and DHD
Controller
Proceed as follows to connect the PlasmaWall to the DHD Controller, your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Connecting the
PlasmaWall to the DHD
Controller
Connect the DHD Controller to the PlasmaWall as shown in Figure 3-3 and described in
the sections that follow.
Figure 3-3. Connecting the PlasmaWall to the DHD Controller
COMBINATION
IN
OUT
RS-232C
AUDIO AUDIO
INPUT1
AUDIO
OUTPUT
INPUT2
ANALOG RGB OUT
(D-Sub)
ANALOG RGB IN
(D-Sub)
INPUT1
DIGITAL RGB
(DVI-D)
INPUT2
Pb
Pr
Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
HD1
HD2
1
2
R/Pr
G/Y
B/Pb
R/Pr
G/Y
B/Pb
H
V
DVI 1
DVI 2
DVI Out
H/V
V
H
R/Pr
G/Y
B/Pb
H
V
TRIGGERS
RS-232 Out
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
!
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
100-230VAC 50-60 Hz, 165 Watts Max
OUTPUTS
INPUTS
SYSTEM CONTROL INTERFACE
Component Video
SDI
Option
Serial No
Video Processor / Controller
Model
Runco International
Union City, CA
Made In USA
ANALOG
RGB IN
(INPUT 1)
DIGITAL
RGB
(INPUT 2)
RS-232C
DHD Controller
RS-232
OUT
DVI
OUT
RGB-HV
OUT