RIDGID 700 - Manual (Page 12)

Ridge Tool Company 10
No. 700 Portable Power Drive
Accessories
Only the following RIDGID products have
been designed to function with the 700 Power Drive.
Other accessories suitable for use with other tools may
become hazardous when used on this Power Drive. To
prevent serious injury, use only the accessories listed
below.
Accessories For Power Drive
NOTE! See Ridge Tool catalog for listing of pipe sup-
ports, vises and thread cutting oil.
Threaders:
Drop Head Threaders
12-R
00-R
11-R
00-RB
Geared Threaders
141 2 1 /
2
″ – 4 ″ Pipe (NPT or BSPT)
161 4 ″ – 6 ″ Pipe (NPT or BSPT)
Contact a RIDGID distributor or consult the Ridge Tool
catalog for specifications and catalog numbers.
Maintenance Instructions
WARNING
Make sure Power Drive is unplugged from power
source before performing maintenance or mak-
ing any adjustments.
Motor Brush Replacement
Check motor brushes every 6 months and replace brush-
es when they are worn to less than
1 /
4
″ .
Lubrication
Grease face gear and bearings every 3 to 6 months
depending upon the amount of use. Grease fitting is pro-
vided on the gear housing.
Tool Storage
Motor-driven equipment must be kept
indoors or well covered in rainy weather. Store the Power
Drive in a locked area that is out of reach of children
and people unfamiliar with power drives. This power tool
can cause serious injury in the hands of untrained users.
Service and Repair
WARNING
Service and repair work on this Power Drive must be
performed by qualified repair personnel. Tool should be
taken to a RIDGID Independent Authorized Service
Center or returned to the factory. All repairs made by
Ridge Tool Co. service facilities are warranted against
defects in material and workmanship.
When servicing this Power Drive, only
identical replacement parts should be used. Failure to fol-
low these steps may create a risk of electrical shock or
other serious injury.
If you have any questions regarding the service or repair
of this machine, call or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-mail: [email protected]
For name and address of your nearest Independent
Authorized Service Center, contact the Ridge Tool Com-
pany at (800) 519-3456 or http://www.ridgid.com
WARNING
Description
Adapter for 00-R & 00-RB
Adapter for 0-R
Adapter for 11-R
Adapter for 111-R
Square Drive Adapter
Support Arm for No. 700 Power Drive
Metal Carrying Case for No. 700 & Accessories
Oiler w/1 Gal. Nu-Clear Thread Cutting Oil
Gearhead Motor Grease
Model No.
770
771
772
773
774
775
B-171-X
418
—
WARNING
WARNING