Roland RM-700 - Manual (Page 160)

161
Creating and Editing Songs
You can re-record part of a passage as you listen to a recorded
performance. This recording method is called “Punch-in Recording.”
This convenient function lets you record over a specified points in a
part as you listen to a prerecorded performance in another section.
Punch-In Recording by the following two methods:
Recording the Region Defined by Markers A and B
(Auto Punch-In/Out)
Before you start recording, place markers A and B to define the
passage you want to re-record. Make the setting for punch-in
recording, and re-record just the passage between markers A and B.
Recording From the Point at Which the Pedal or Buttons
Are Pressed (Manual Punch-In/Out)
You can play back a performance and depress the pedal at the
desired place to start re-recording. Depressing the pedal a second
time cancels recording and returns you to playback.
Instead of pressing the pedal, you can press the [ (Rec)] button to
start and cancel recording.
Recording a Passage Specified by Markers
1. Before you start re-recording, place markers A and B to
define the passage.
Following the procedures described in “Setting Markers for
Repeated Practice (Marker)” (p. 118), use Markers A and B to specify
the passage.
2. In the “Rec Mode,” select <Auto Punch In/Out> (p. 159).
3. Begin recording.
Begin recording using the procedures described in “Recording
While Selecting the Track Buttons (Redoing Recordings)” (p. 131) or
“Multitrack Recording with 16 Parts (16-Track Sequencer)” (p. 156).
Up until the specified passage, the previously recorded performance
plays back.
When you reach the specified passage, sounds are erased as
recording starts; begin playing now.
When you reach the end of the specified passage, recording stops,
and the RM-700 returns to playback of the previously recorded
performance.
4. When you press the [ (Play/Stop)] button, the song
stops.
Starting Recording from the Measure Specified by
Pedals
If using the pedals, you must first change the function of the pedals.
Follow the procedures in “Assigning the Function of the Pedals (Left
Pedal/Center Pedal/Expression Pedal)” (p. 179), and assign <Auto
Punch In/Out> to the pedal.
1. In the “Rec Mode,” select <Manual Punch In/Out>.
2. Begin recording.
Begin recording using the procedures described in “Recording
While Selecting the Track Buttons (Redoing Recordings)” (p. 131) or
“Multitrack Recording with 16 Parts (16-Track Sequencer)” (p. 156).
The previously recorded performance will be played back.
Press the pedal to which Punch In/Out is assigned (p. 179), or the
[ (Rec)] button to begin recording, then start your performance.
Recording stops when you press the pedal, or the [ (Rec)] button
again, and the previously recorded performance is played back.
3. When you press the [ (Play/Stop)] button, the
performance stops.
* When you’re finished with Punch-In Recording, return to the
ordinary Replace Recording mode.
Re-Recording Part of Your Performance
(Punch-in Recording)
RM-700_e.book 161 ページ ２００９年３月１８日 水曜日 午前１１時５分