Rosen Entertainment Systems Rosen R5505 - Manual (Page 16)

16 R5505
Wiring the DVD player
Read the following precautions before wiring your system.
•
Disconnect the negative battery terminal before making
any wiring connections.
•
Be particularly careful where you route wires. Keep them
away from the engine, exhaust system, etc. Heat may
damage wires.
•
If the fuse should blow, make sure all connections are
correct and no wires are damaged before replacing the
fuse. Always use fuses that are the same amperage value
as the original. When replacing a fuse, never let the battery
side touch any metal part or any other wire.
WARNING!
Not all Rosen and Rosen/necvox products
use identically-wired four-pin power
harnesses! ONLY use the four-pin power
harness supplied with this unit! Use of any
other four-pin harness may cause failure
NOT covered by the manufacturer’s
warranty!
Black
- Ground
Yellow
+12V
Constant
Power
Red
+12V Accessory
Wire side of Power Connector
Red
+12V Accessory
Yellow
+12V Constant power
Black
- Ground
Wire Color Codes
Note: Connect
using proper fusing
with 3A fuses.
Power Harness Connections