Rinnai RHFE-1004FA - Manual (Page 16)

INSTALLATION INSTRUCTIONS
– 14 –
Check to ensure gas type on rating plate matches gas being supplied to the unit. If not, unit may have
been converted and should be checked to ensure conversion was done properly. If not, unit could be
damaged due to being overfired.
Refer to local gas authority for confirmation of gas type if in doubt.
Refer to data plate located inside of the front panel.
Check for damage, if the unit is damaged contact your supplier or Rinnai.
Do not install a damaged unit before checking with your supplier.
Refer to an approved pipe sizing chart if in doubt about size of gas line.
Flue Manifold 1
Spare rubber seal
1
(‘A’ Flue units only)
(For weatherboard installations)
Back Spacer
Set
1
1
1
2
1
1
7
3
1
7
1
1
2
Air inlet hose
Vent adaptor
Pipe stopper
A&S
Pipe stopper
E
Wall
Brackets
Insulation
Clip
Plastic tie for
air inlet
(M4)
(M4 20)
(M4)
(M4.8 32)
Wood Screws
Owner’s Manual
Conversion Manual
Template
For Flue Lock Stopper
For Flue Manifold
Wall Bracket Screws
For Back Spacer Set
4 (M5)
For Wall Brackets