Safety precautions, Operating the tool, Always hold tool perpendicular to work surface – Remington 489 User Manual
Page 8
Safety Precautions
6
YES
7.
DO NOT drive power fasteners into steel base material less then 3/16" thick,
within 2" of a weld, within 1/2" of the edge, or within 1" of another power fastener.
3"
3"
3"
482-39
6.
DO NOT drive power fasteners into concrete less than three times as thick as
the intended fastener penetration, within 3" of the edge, within 3" of another
power fastener, or within 3" of a failed power fastener.
8.
When fastening into masonry walls, always drive into horizontal mortar joints,
NEVER into vertical mortar joints. BE CAREFUL. A poorly laid joint may permit
too much penetration and/or unsatisfactory holding power.
OPERATING THE TOOL
1.
ALWAYS hold tool perpendicular to work surface.
3/16" MIN
1/2"
1"
482-41
3"
3X
1X
482-38
TOO THIN
WELD
482-40
G 018
NO
489-29
G 018
90˚