RCA CC632 - Manual (Page 48)

Playback on a TV Without Audio and Video Inputs
46
Disconnect the VHF antenna from
your TV. If you are going to leave
the RF adapter connected to the TV,
connect the antenna to the RF output
adapter.
A.If antenna is round 75-ohm cable,
connect it to IN FROM ANT
connector on RF output adapter.
B.If antenna is flat twin-lead,
connect flat-lead connectors to
screw terminals on optional 300-
75 ohm transformer. Then
connect transformer to IN FROM
ANT connector on RF output
adapter.
Attach one end of coaxial RF cable
to OUT TO TV connector on RF
adapter, and attach other end of the
cable to VHF input on TV as shown.
Note: If TV has screw terminals, you
may need an optional 75-to-300 ohm
transformer, such as AH011.
Attach RF output adapter’s yellow
plug to the VIDEO jack, small plug
to the RF DC OUT jack, and white
plug to the AUDIO jack on the side
of the camcorder.
Place the AV OUT/IN switch to
OUT.
To connect your camcorder to a TV without audio and video input jacks. You will
need an optional RF output adapter (such as CRF95) and an optional coaxial RF cable
(such as AH065G or AH066G) shown on page 54.
AV
OUT / IN
LIGHT AUTO OFF ON
FADE
TRACKING REC/PAUSE
OFF OWER VCR AV DUB REW PLAY F.FWD STOP/EJECT
TITLE SEL – + EDIT – ADV
1A
3
Optional Coaxial RF Cable
(such as AH065G or AH066G)
Channel Selector
Optional RF Output Adapter
(such as CRF95)
Optional 300/75 ohm
Transformer
(such as 193983)
1B
IN
FROM
ANT
OUT
TO TV
AV OUT/IN Switch 4
OR
OR
OR
VHF
VHF
Back of TV
Antenna
Antenna
Optional 75-300 Ohm
Transformer
1 2
3
4