ResMed HumidAire 2i - Manual (Page 5)

Clinical Use Only
5
Disassembling and Reassembling the HumidAire 2i
WARNING
Beware of electrocution. Do not immerse the device or power cord in water. Always unplug the device before
cleaning and be sure that it is dry before plugging back in.
1 Turn the main power switch at the back of the device to OFF, and unplug the power cord from the power outlet.
2
Allow 10 minutes for the tub plate and any excess water to cool.
3
Remove the water chamber. To do this, lift the latch at the bottom of the water chamber and pull the water chamber
away from the docking station.
4
Discard any excess water by turning the water chamber upside down, allowing the water to drain out of the air outlet.
5 Disassembling the Water Chamber
1. To open the side catches pull out from the lower edge.
2. Separate the water chamber by pulling the two halves apart. Use your thumb to pull down on the front tab.
3. Inside the chamber lid is the seal. Remove the seal by peeling it away from the inside of the lid.
4. Remove the cross-member from the water chamber base.
Side catch
Front tab
Seal
Lid
Base
Cross-member