Recoton/Advent EC Series - Manual (Page 11)

EC Series EN-7
4 OPERATIONS
4.1 Switching the Unit On and Off
The power switch is located underneath the right-hand side of the scale. Push the
switch to the “I” position to turn the scale on, and to the “O” position to turn the
scale off. Allow 15-30 minutes for the scale to warm up before use.
NOTE: Make sure the weighing pan is empty before turning the scale on.
4.2 Manual Tare
Tare is indicated by the Q Q Q Q QT annunciator.
Place the container on the weighing
pan (ex. 100g), then press TARE.
“tARE” will be displayed momentarily
before the weight is tared. ------ .
0.0 .
Weight g
100.0 .
tArE
0.0 .
Piece Weight g/pc
0. .
------ .
0. .
Count pcs
0. .
With an empty pan:
Press PT, “PrEtA” will flash on the
display. Enter a numeric value (ex.
200g), then press PT. The Pre-set
Tare will be displayed as a negative
value (no weight on the pan).
200.0 .
-200.0 .
Weight g
0.0 .
PrEtA PrEtA PrEtA PrEtA PrEtA
0. .
Piece Weight g/pc
PrEtA PrEtA PrEtA PrEtA PrEtA
------ .
------ .
Count pcs
------ .
4.3 Pre-set Tare
Pre-set Tare is a known tare value entered via the numeric keypad
Pre-set Tare is indicated by the
Q Q Q Q QT annunciator.
With an existing weight on the pan
(ex. 250g):
Press PT, “PrEtA” will flash on the
display. Enter a numeric value
(ex. 200g), then press PT.
The Net weight will be displayed.
When the weight is removed from the
pan, the negative weight displayed
is the Pre-set Tare value.
NOTE: To clear the Tare or Pre-set Tare value, press TARE with the pan empty.
0.0 .
200.0 .
Weight g
250.0 .
PrEtA PrEtA PrEtA PrEtA PrEtA
PrEtA PrEtA PrEtA PrEtA PrEtA
Piece Weight g/pc
0. .
------ .
------ .
Count pcs
0. .
50.0 .
-200.0 .
0. .
0. .
0. .
------ .
3 EC-textEN.pmd 8/9/2005, 1:41 PM 7