Ryobi P301 - Manual (Page 11)

11
LATCH
OPERATION
Fig. 3
BATTERY
PACK
LATCHES
DEPRESS LATCHES TO
RELEASE BATTERY PACK
Fig. 4
STAPLES
Fig. 5
NOTE: This situation only occurs when continuous use of the
tool causes the batteries to become hot. It does not occur
under normal circumstances. Refer to CHARGING A COOL
BATTERY PACK for normal recharging of batteries. If the
charger does not charge your battery pack under normal
circumstances, return both the battery pack and charger
to your nearest Authorized Service Center for electrical
check.
TO INSTALL BATTERY PACK
See Figure 3.
� Place battery pack in your tool. Align raised rib on battery
pack with groove inside tool.
� Make sure the latches on each side of the battery pack
snap in place and battery pack is secured in tool before
beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised
rib on battery pack aligns with the bottom of the tool
and latches into place properly. Improper installation
of the battery pack can cause damage to internal
components.
TO REMOVE BATTERY PACK
See Figure 3.

Locate latches on side of battery pack and depress to
release battery pack from the tool.
 Remove battery pack from the tool.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be locked when not in use or
carrying at your side.
LOADING THE TOOL WITH STAPLES
See Figures 4 - 5.

Remove battery pack from the tool.
 Hold tool upside down; squeeze latch and slide base
open.
 Place staples in channel, legs facing upward and close
base.
 Make sure the latch is securely locked in place.
 Reattach battery pack to tool.