Runco CRYSTAL CX-OPAL47 - Manual (Page 63)

Serial Communications
CX-47HD/CX-OPAL47/CX-65HD Installation/Operation Manual 49
PRE
L
IMINAR
Y
[ SDE 000# Set PIP aspect ratio
0 = 4:3
1 = 16:9
Example: [SDE0001 selects 16:9 aspect ratio PIP window
[ SDF 000# Set PIP window position
0 = Top/Left
1 = Top/Right
2 = Bottom/Left
3 = Bottom/Right
Example: [SDF0001 positions PIP window in upper-right corner of display area
The following serial commands are meant to emulate buttons on the remote control. Each button
has its own serial command, so effectively it is as if you were using the IR remote only you’ll be
doing so via serial commands. These commands provide active OSD responses just like the IR
remote.
Each command begins with [key followed by the four-digit number of the button. No carriage
return is necessary. The response you receive from the unit if the command is valid will be a
right-bracket (
] ) followed by the four-digit numeric code you sent. (For example, the ‘ON’ com-
mand is [key0015 ; the response will be ]0015 ). All commands are in ASCII.
[ key 0002 OFF
0015 ON
[ key 0004 Number 1
0005 Number 2
0006 Number 3
0008 Number 4
0009 Number 5
0010 Number 6
0012 Number 7
0013 Number 8
0014 Number 9
0035 Number 100
0017 Number 0
[ key 0102 HDMI 1
0101 HDMI 2
0093 HDMI 3
0094 HDMI 4
0028 Component 1/SCART
Table 6-1. Serial Commands (continued)
Command Description