The hardware installation procedure – RCA 300 Series User Manual
Page 16
2 SpeedTouch™ Installation
E-SIT-CTC-20030702-0003 v4.0
14
The hardware
installation procedure
Proceed as follows:
1
Use the ADSL cable provided to wire the SpeedTouch™ ADSL port to your tele-
phone wall outlet or distributed filter.
2
Insert the SpeedTouch™’s USB connector into the computer’s USB port.
A USB port can be easily located, it is marked with the typical USB symbol:
.
Note
You can also connect your SpeedTouch™ to the computer via a USB
hub.
3
MS Windows will automatically recognize the SpeedTouch™:
4
The Found New Hardware Wizard finishes the installation by setting up the Speed-
Touch™’s ADSL Wide Area Network (WAN) connectivity.
The installation of the SpeedTouch™ is now finished. The SpeedTouch™ is now
prepared to connect to the Internet (See
“3 SpeedTouch™ Internet Connectivity” on
).