The hardware installation procedure – RCA 300 Series User Manual
Page 26
2 SpeedTouch™ Installation
E-SIT-CTC-20030702-0003 v4.0
24
9
At the end of the procedure, the following window appears:
Click Restart to quit the installer.
The hardware
installation procedure
After restarting your computer, proceed as follows:
1
Use the ADSL cable provided to wire the SpeedTouch™ ADSL port to your tele-
phone wall outlet or distributed filter.
2
Insert the SpeedTouch™'s USB connector into the computer's USB port.
A USB port can be easily located, it is marked with the typical USB symbol:
.
Note
You can also connect your SpeedTouch™ to the computer via a USB
hub.
3
Click System Preferences on the Apple menu.
4
Click the Network icon in the System Preferences window.
5
Following window prompts you that a new port has been detected:
Click OK.
6
The Network window appears:
In the Show list, click Active Network Ports (or Network Port Configuration(s)), and
drag:
•
SpeedTouch™ USB to the top of the list in case of PPP connectivity.
•
Ethernet Adaptor (enx)
to the top of the list in case of RFC1483 connectivity.
7
If you do not intend to use the other interfaces, clear the corresponding check
boxes.
Click Apply Now to confirm the modifications to the network settings.