Raymarine 81285_1 - Manual (Page 14)

12 Raymarine Satellite TV Systems
2. Connect a 15 m RF cable between LNB RHCP +13 V of the
multiswitch and RF2 on the antenna baseplate.
3. Connect a 30 cm RF cable between To Multiswitch18V on
the DiSEqC supplier and LHCP (+18V) on the multi-switch.
4. Connect a 3 m RF cable between From HD-ACU on the
DiSEqC supplier and Receiver on the HD-ACU.
5. Connect a 30 cm RF cable between From multiswitch out on
DiSEqC supplier and any OUT of the multi-switch.
6. Connect an RF cable between Master receiver on the
DiSEqC supplier and the Master IRD.
With the system powered:
• Set the ACU to ON.
• The IRDs to OFF.
• The television to OFF.
7. Confirm that the antenna detects and tracks the DirecTV101
satellite.
8. Set the Master IRD to ON.
9. Set the television connected to the master IRD to ON.
The system can now be controlled using the Master IRD.
Power settings
HD-ACU and multiswitch
When using DirecTV with a multiswitch, the power setting for
each of the satellites (DTV101, DTV119, and DTV110) should
be set to AUTO. This is the default setting on the HD-ACU. If you
need to change the settings, this can be achieved in one of two
ways:
• Using the PC program on the Installation CD.
• Manually change the power setting.
Using the PC program
1. Connect your PC to the HD-ACU.
2. Run the Installation CD.
3. Open the folder named DirecTV with multiswitch.
4. Enter Setup Mode.
5. Click View Data. The default settings are loaded.
6. Click Update antenna. The new settings are sent to the
antenna.
7. Click Restart. The antenna is initialized using the new power
settings.
Manually changing the settings
1. Press YES to enter set up mode.
2. Press NEXT twice to enter Edit Sat
Info menu.
3. Press YES to enter edit menu.
4. Press NEXT until the power
supplying method screen is
reached.
D7973_1
SETUP MODE?
YES NO
D7974_1
SET SAT PAIR?
PREV YES NEXT
D7983_1
EDIT SAT INFO?
PREV YES NEXT